John Deere LPBST-35JD Manuel d'utilisateur télécharger pdf (Page 6)

Installing - 5

INSTALLING

MX39207

2. Install 3/8 in. ID O-ring (E) on transmission shaft (F) until seated on

bottom of hopper (G).

3. Install agitator (H), and secure with 1/8 x 1 in. cotter pin (I) through top

loop in agitator and hole in transmission shaft, as shown.

MX39208

4. Make sure transmission bracket (J) is on top of nuts (K) on hex bolts (L),

and install control support tube (M) onto bolts (L). Secure with 5/16 in.

locknuts (N). Tighten locknuts.

MX39209

5. Install hitch clevis brackets (O) onto tow tube end (P) with two 5/16 x 2

in. carriage bolts (Q) and 5/16 in. locknuts (R), as shown. Tighten

hardware.

6. Install 1/2 x 2-1/2 in. hitch pin (S) and 1/8 in. spring locking pin (small)

(T) through end of clevis brackets, as shown.

Installing

Installing the Spreader

1. Park machine safely. See “Parking Safely” in Safety section.

MX39210

2. Remove 1/8 in. spring locking pin (A) and 1/2 x 2-1/2 in. hitch pin (B)

from hitch clevis (C) of spreader.

3. Pull spreader forward and position hitch clevis to straddle machine rear

hitch plate or drawbar (not shown). Align all hitch pin holes, then install

hitch pin down through hitch clevis and machine hitch, securing with 1/8

in. spring locking pin (small).

IMPORTANT: Avoid damage! To avoid transmission damage, do

not adjust slot in transmission bracket forward or rearward. The

slot will self center as hardware is tightened.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

John Deere LPBST-35JD Manuel d'utilisateur Page 6